The RFAX1000 PST (Thermistor) Air Probe is a damped air probe for use with our wireless temperature monitoring systems and compatible with the C42C unit. The probe is connected to a 10.0m lead.
The RFAX1000 PST Air Probe is fitted with a 6-Pin Lumberg connector with locking screw, to provide a strong and secure probe-to-instrument connection with better prevention of liquid ingress.
Name | Value |
---|---|
Lead Length | 10.0m |
Connector Type | Lumberg (6-Pin) |
Sensor Type | PST (Thermistor) |
Stem Length | 30mm |
Stem Diameter | 8mm |
Temperature Range | -40 to +70°C / -40°F to +158°F |
Wire Type | Flat-Twin |
Lead Material | PVA |
Warranty | 6 Months |
It is fair to say, that any probe that can measure temperature, could be used as an Air Probe, with varying degrees of success. However, Air Probes are specifically designed for this purpose and so have a higher degree of accuracy and response.
Air Probes are often designed to be very quick response with a low thermal mass. The sensor is designed to be as small as possible so that the air temperature is transferred to the probe with minimal temperature loss or gain to maintain a high degree of accuracy.
That said, all Comark Air Probes for Wireless Temperature Monitoring Systems are inherently designed to be slow. Why is this? Read on to find out….
We supply a Damped Air Probe style for our Wireless Temperature Monitoring System, which comes in the form of a small stainless steel bullet shaped end.
This type of construction has two purposes;
In certain scenarios, it is beneficial to have a slower response to changes in air temperature, hence having a Damped Air Probe. For example, when you place a probe inside a fridge or freezer, you probably don’t want an alarm going off every time someone opens the door.
The Damped Air Probes do a good job of reflecting the samples in the fridge. As our Wireless Temperature Monitoring Systems are your early warning notification for any alarms, it would be unsuitable if ‘false alarms’ were constantly being raised.
All Wireless Temperature Monitoring System Air Probes are fitted with a 6-Pin Lumberg Connector and a stainless steel Damped Air Probe end, as shown below.